CarPro CQUARTZ DLUX 2.0

CQDLUX2.0 Yet another famed flagship of ours receives a makeover. DLUX 2.0 arrives with upgrades in all key aspects of performance.

Dlux 2.0, has all of the original attributes you love, with the addition of a smoother, slicker surface and increased water spot resistance. Treat alloy wheels and plastics with DLUX 2.0 to restore their rich, glossy finish, and give them the lasting hydrophobic nanotechnology protection.

Such surfaces have to withstand a lot of abuse so DLUX 2.0 was given a thicker film build compared to other CQUARTZ coatings, and a 50% silica content by volume. On painted, polished or chromed wheels, DLUX 2.0 resists brake dust and road grime, limiting the need for dedicated cleaners.

DLUX 2.0 has been modified with hybrid synthetic siloxane, reducing its viscosity, whilst maintaining overall film thickness, protection, and simplifying application: when laid down evenly, buffing may not be required in many conditions.

That same reduced viscosity also makes DLUX 2.0 more forgiving on wipe-off: even where a pass isn't perfectly even, residue lifts away cleanly rather than requiring a second correction, making the whole install noticeably less fussy end to end.

Directions

Wheels

1. Cleaning & Decontamination

• Fully clean with Carpro Wheel X, then follow up with Tar X.

• Once cleaned, lightly clay the wheel faces and inner with your dedicated

clay towel.

2. Panel Preparation

• Degrease: Spray the wheel liberally with Carpro Eraser to remove remaining oils.

• Dry: Wipe clean with a microfibre cloth and buff dry with a second towel.

3. Application

• Load: Pour an adequate amount of Dlux 2.0 onto the applicator suede.

• Spread: Apply evenly across the prepared surface to form a uniform layer.

4. Levelling & Finishing

• After 2 to 3 minutes. Lightly wipe over the coated section with light pressure.

Once complete, use a second microfibre to carry out a further dedicated wipe

over. Ensuring all surplus coating is fully removed.

Plastic Trims

1. Cleaning & Decontamination

• Strip: Remove old silicone dressings using CarPro ReTyre and a stiff-bristled

brush.• Restore: Scrub heavily oxidised trim with a magic eraser to expose a fresh

surface.

2. Panel Preparation

• Degrease: Spray the trim with Carpro Eraser to remove remaining oils.

• Dry: Wipe clean with a microfibre cloth and buff dry with a second towel.

3. Application

• Load: Pour an adequate amount of Dlux 2.0 onto the applicator suede.

• Spread: Apply evenly across the prepared surface to form a uniform layer.

4. Levelling & Finishing

• Textured Trim (Gloss): Leave the coating untouched for a high-gloss finish.

• Textured Trim (Satin): Buff lightly with a microfibre cloth after 2 to 3 minutes.

• Smooth Plastics: Buff immediately to level excess product and prevent high

spots.

Please ensure all coated sections remain free of standing water for a 24 Hour period.

Full hardness and chemical resistance are achieved after 7 days